FlightFX Hawker 800XP pack - for CTC Aircraft Maintenance

Load the FlightFX Hawker 800XP and CTC Aircraft Maintenance recognises it and opens an airframe with everything the app does: tech log and MEL, part wear, scheduled inspections, stores, documents and the maintenance desk.

- Aircraft EFB page: live Electrical (DC buses, bus tie, batteries, AC and backup), Fuel, Pneumatic, Hydraulic and Engines pages with an animated TFE731 cutaway, drawn from the Hawker's own system values: hydraulic pressure at every user, accumulators, emergency brake, fluid temperature, cabin altitude and rate, DEEC throttle angle and N1 target. Click any pump, valve, generator or engine section to open its part.

- FlightFX's own wear counts: the Hawker tracks 144 components itself. CTC reads them all - a part never reads better than the aircraft says, and a component the aircraft fails is written up in the tech log. The Service & Maint page shows TKS fluid, hydraulic main and aux, oxygen, fire bottles, tyre pressures, engine health and Hobbs, and how long since the airframe was washed.

- Hawker 800XP maintenance: two TFE731-5BR engines with DEEC and APR, target thrust reversers, starter-generators, inverters, TKS ice protection, stick pusher, rudder bias, Mach trim, lift dump and air brakes, the auxiliary hand pump - all as parts that wear with how you fly.

- The Hawker programme: pre-flight, 7-day, phase inspection every 200 h, the 12-month / 600 h inspection, and the TFE731 Major Periodic Inspection (2,100 h) and Core Zone Inspection (4,200 h).

- Hawker MEL: 18 items with placards and operating procedures, from the stick pusher (NO GO) to a reverser locked stowed.

- Failures set in the aircraft where they can be confirmed: engine failure, pitot blockage and engine fire, each read back after it is set.

Independent add-on; not affiliated with FlightFX or Microsoft.